Added: Dec 1, 2008

From: manchild002

Duration: 10:1

Joe Pipe Gasifier using 4 inch square tube by 10 inches with a 1 inch inlet tube for the wood pellets. Extreem production of wood gas converting even wet pellets into a burnable fuel.

Channel: Tech

Tags: ammonia  arc  bio  cell  communities  community  denice  energy  gas  gasification  geet  green  heat  hho  homeless  hydrogen  hydroxide  into  joe  joshua  lee  living  man  meyers  nwo  pipe  point  producer  project  quantum  refrigeration  rocket  self-reliant  shelters  stanley  steam  superheted  the  unlimited  wood  zero 

Rating: 5.00 (3 ratings)    Views: 284    Comments: 5

2icaros Says:

Dec 1, 2008 - beautifull indeed,congratulations

manchild002 Says:

Dec 1, 2008 - Hey Again-Yes, the sub-state of plasma heat has been reached using wood gas. Wonder what it will do adding Robb's swirl device to super enhance the vortex? Maybe white plasma??

plasmastudent77 Says:

Dec 8, 2008 - If it runs hotter than say 2000F, if you inject water it should be hot enough to crack the water into hydrogen and oxygen and burn and then become effectively water powered. Have you tried that? How hot does the core flame get when its at optimum temp please?

manchild002 Says:

Dec 8, 2008 - Hi-The core temperature is hotter than the pipe but not having the right kind of equipment I can only guess at the temperature.Lots of purple and violet in the blue. The next modification I need to replace the copper coil, shield it with alum. foil and insulation. Then cover it over with a length of 4 inch ss pipe, insulate and finish off with a 8 inch section steel stovepipe. Did add some water today but the conversion to steam blue out the flame. Need to add raw flame and see what happens.

plasmastudent77 Says:

Dec 8, 2008 - Hi- the h20 injection could become self sustaining. Have you tried adding a very very small ammount of water direct into the core , or, wrap a 1/4 inch copper pipe around the end of the pipe to flash a very small ammount of water into steam and then feed that in minute ammounts into the core or perhaps behind the core ( core = the hottest bit of the flame ) so the air/gas mix sucks it into the core, and see what happens. 20000 Troops = New Praetorian Guard. All hail Ceasar.

manchild002 Says:

Dec 8, 2008 - Hi Again-Had difficulty with stablizing the flame with the addtion of the larger air pipe. To return it back to former operartions, I took six 1 1/2 ss washers and wrapped them together with some ss wire. Adding the swirl devide just into the Level 3 flame is producing a purple blue. Have a 25 ft. 1/2 copper coil but need to fit it in with the modifications to the front part of the pipe. The steam will enhance the production of hydrogen. Hopefully a trigger point will be reached.

ATAINC23 Says:

Dec 24, 2008 - Daniel did you move your site? I've been away for a while and it looks like you haven't been on recently

joepipe101 Says:

Dec 25, 2008 - Hi Atainc23-I've opened up a new u tube account under joepipe101. The old manchild 002 account would not upload past vid 209. Been doing a lot of testing here using various swirl devices.I've uploaded to 230 and have at least another 30 to go. Lots of purple being generated now.Metal going to yellow point and flame into ultra violet. Robb R. in Michigan in his joe pipe is melting his cast iron test piece with his. By far the Joe Pipe is proving to generate the most heat with the least fuel.